Dexter-laundry T-30 (On-Premise) User Manual

8514-209-001A May 2012 OPERATOR’S MANUAL For DCBD(30/50/80)HC-10/39 Series Dryers The dryer must not be stored or installed where it will be exposed

- 10 - 7. DRYER IGNITION (SOLID STATE IGNITION). The solid state ignition system lights the main burner gas by spark. The gas is ignited and burns

- 11 - Figure 3 – Non-Reversing Dryer Controller Interface.

- 12 - DRYER CONTROLLER FACTORY DEFAULT PROGRAM SETTINGS DRY CYCLE COOL DOWN TIME (minutes) TOTAL CYCLE TIME (minutes) DRYING TEMPERATUREDRYER LOAD

- 13 - TOUCH PAD DESCRIPTION INDICATOR LIGHTS (L.E.D.s) Description Cycle (1 through 5) These L.E.D.s are on solid when a particular cycle is chosen

- 14 - 4-DIGIT NUMERICAL DISPLAY MESSAGES Description LOAd This message is displayed after a dry cycle is complete and the dr

- 15 - OPERATING INSTRUCTIONS To dry a load of items, you must choose one of the five-programmed dry cycles. Each of these five dry cycles may be mod

- 16 - The bottom and middle pins are for Celsius and the top and middle pins are for Fahrenheit, which is indicated by the letter C for Celsius and t

- 17 - 5) Press and release the SELECT/ENTER touch pad switch on the dryer controller. Once the SELECT/ENTER touch pad switch is pressed and releas

- 18 - 3) Press and release the UP touch pad switch on the dryer controller 10 times so that the display will show a flashing “45”. When the UP touc

- 19 - cycle L.E.D. and the programming L.E.D. will remain illuminated, and the total dry time will also be displayed on the 4-digit numeric display.

- 2 - TABLE OF CONTENTS DRYER DIMENSIONS (Figure 1)...…...3 DRYER CAPACITIES...

- 20 - PROCEDURE: 1) After the load has been placed in the dryer, press and release either the UP or DOWN touch pad switch on the dryer controller

- 21 - SERVICING THE DRYER CAUTION: Label all wires prior to disconnection when servicing controls. Wiring errors can cause improper and dangerous op

PREVENTIVE MAINTENANCE INSTRUCTIONS DAILY 1. Clean the lint screen. Use a soft brush if necessary. 2. Check the lint screen for tears. Replace if

- 3 - DRYER DIMENSIONS- FIGURE 1A

- 4 - DRYER DIMENSIONS- FIGURE 1B

- 5 - DRYER DIMENSIONS- FIGURE 1C

- 6 - DRYER CAPACITIES Dryer Model Dry Weight Capacity DCBD30 30 lb (13.6 kg) DCBD50 50 lb (22.7 kg) DCBD80 80 lb (36.3 kg) INSTALLATION AND OP

- 7 - Refer to installation label attached to the inside surface of the upper door of the dryer for other installation information. VERTICAL CL

- 8 - Individual circuit breakers for each unit are recommended. The wiring diagram is located on the belt guard on the back of the machine. IMPORTANT

- 9 - This pipe must be very smooth on the inside, as rough surfaces tend to collect lint which will eventually clog the duct and prevent the dryer fr