Dexter Laundry DDAD50KC Series Operator's Manual download pdf (Page 12)

DRYER PREVENTIVE MAINTENANCE (PM) REQUIREMENTS

MAKE SURE ALL POWER IS DISCONNECTED BEFORE

SERVICING MACHINE

DAILY

1. Clean lint screen using a soft brush if necessary. Check lint screen for rips or tears and replace if damaged.

MONTHLY

1. Clean lint from motor end bells and dryer controls area.

2. Clean lint from lint screen compartment.

3. Clean lint accumulation from top and all areas above, around and below burners and burner housing. Failure

to keep this section of dryer free from lint can create a fire hazard.

SEMI-ANNUALLY

1. Check V-belts for cracks, wear, fraying, or looseness.

2. Inspect all fasteners (screws, bolts, nuts, etc.) and tighten any that are loose.

3. Clean all lint accumulation from inside of front panel.

4. Place a few drops of light oil on top and bottom pivots of the door hinge.

5. Inspect door glass gasket for excessive wear.

6.Clean lint accumulation from the burner primary air ports.

7.Check intermediate drive pulley bushings for excessive wear.

ANNUALLY

1. Remove, inspect and clean main burner orifices of obstructions or dirt.

2. Grease intermediate drive pulley bearing at zirk grease fitting.

3.Inspect and remove any lint accumulation in the exhaust ducts. Inspect all ducting from the dryer exhaust

connection to the exit wall or roof.

4.Check tumbler shaft retaining nut for 125 Ft. pound torque.

SERVICING DRYER

CAUTION: Label all wires prior to disconnection when servicing controls. Wiring errors can cause improper and

dangerous operation. Verify proper operation after servicing.

ATTENTION. Lors des opérations d'entretien des commandes, étiqueter tous les fils avant de les déconnecter. Toute

erreur de câblage peut être une source de danger et de panne.

1 2 ... 7 8 9 10 11 12 13 14

No comments

Dexter Laundry DDAD50KC Series Operator's Manual Page 12