8514-141-001The dryer must not be stored or installed where it will be exposed to water and/or weather.OPERATOR’S MANUALforDDAD50KC Series Dryerscmanu
FIGURE 4 - Top View Of Controller.SL9-0229The controller is put into the programming mode by opening both dryer doors and actuation of a switch on the
DRYER PREVENTIVE MAINTENANCE (PM) REQUIREMENTSMAKE SURE ALL POWER IS DISCONNECTED BEFORESERVICING MACHINEDAILY1. Clean lint screen using a soft brush
Instructions - Convert a Dual Voltage Stack Dryer from 120V to 208-240V with Neutral Wire Only 1. Remove incoming power from the dryer. Use a know
Contact Information: Address: Dexter Laundry Inc. 2211 W. Grimes Ave. Fairfield, IA 52556 Phone: 1-800-524-2954 Website: www.dexterlaundry.com
2WARNINGS ABOUT USE AND OPERATIONKEEP SHIELDS, GUARDS AND COVERS IN PLACE. These safety devices are provided to protect everyonefrom injury.It is ABS
34 1/25186 1/479 3/8GAS INLET4 3/46 7/88" VENT ELECTRICALCONNECTIONSDDAD50 STACKED DRYER
INSTALLATION AND OPERATING INSTRUCTIONSUNCRATING AND PLACING DRYERTools Required: 3/4" hex socket & ratchet driver, wood block 4" or 5&q
The sources of all make-up air and room ventilation air movement to all dryers must be located away from any drycleaners. This is necessary so that s
CAUTION: The dryer and its individual shutoff valve must be disconnected from the gas supply piping system during any pressure testing of that system
7. DRYER IGNITION (SOLID STATE IGNITION): The solid state ignition system lights the main burner gas by spark. The gas is ignited and burns only whe
OPERATING INSTRUCTIONS1. Load clothes into either the upper or lower drum (or both). Close the door(s) completely.2. Deposit coin or coins equal to o
Comments to this Manuals